Receiver-Mount Motorcycle Carrier

[Damage Inc.]

Anybody have a Receiver-Mount Motorcycle Carrier for loan/rent or sale?

[juddspaintballs]

Contact Gene
Three Zero One 356 Two 7 Five One

He has one for sale cheap, I'm sure. It's a HF carrier I fixed so it's actually strong.

[Bork]

Contact Gene
Three Zero One 356 Two 7 Five One

He has one for sale cheap, I'm sure. It's a HF carrier I fixed so it's actually strong.

How did you make it stronger? I'm thinking of getting one. I dont like the looks of the thin 2" aluminum square channel over the the 2"square steel tongue. The see-saw effect would crack/split it?

[juddspaintballs]

The 2" square tube is extremely thin and it wallowed out the hitch pin hole after just a couple uses. The aluminum bracket that holds the horizontal tray to the square tube is also prone to failure. I replaced the 2" square tube with a thicker walled SS tube (only because that hunk of SS was cheap) and used 2" angle iron to hold it on with proper bolts. I also used a piece of 1-1/4" square bolted under the carrier about where the handlebars would be directly above it for easier tie-down of the bike.

Give Gene a call. Since I built him a massive 3'x7' platform that he's using on the back of his truck, he doesn't need the HF carrier anymore.

[Bork]

OK, thanks for the info but didn't want to buy out from under "Damage inc" .
Also looks like he might be pretty far east?, according to his phone #. I'm closer to Frostburg, probably not worth the drive. Unless someone wants to drag to Mountain Ridge to meet me.

[juddspaintballs]

He's Brunswick.

[Damage Inc.]

If you want it go for it he's too far away from me to be worth it.

[Bork]

Thank you. I made contact.

[Bork]

Done deal, Thank you!